Changeset 3829
- Timestamp:
- 04/25/04 01:55:22 (21 years ago)
- Location:
- trunk/MagicSoft/Mars
- Files:
-
- 2 edited
Legend:
- Unmodified
- Added
- Removed
-
trunk/MagicSoft/Mars/Changelog
r3825 r3829 19 19 -*-*- END OF LINE -*-*- 20 20 21 2004/04/25: Abelardo Moralejo 22 23 * mbadpixels/MBadPixelsTreat.cc 24 - Change in line 204: if ((*fBadPixels)[i].IsBad()) by 25 if ((*fBadPixels)[j].IsBad()) The way it was done, it never 26 worked, because the check on whether the neighbour pixels 27 were OK was performed on the same pixel to be treated (i), which 28 is obviously not OK. The same problem fixed in the interpolation 29 of pedestals. Amazingly, this error would have shown up in any 30 test of the class.... I assume it must have been commited 31 completely untested. 32 33 - In InterpolateSignal: moved division of summed charge over 34 number of pixels : put it after the check of the number of 35 valid neighbours to avoid division by 0. 21 36 22 37 … … 26 41 - fixed a bug in the ReInit() for the number of average events in 27 42 each area index and sector 28 29 43 30 44 -
trunk/MagicSoft/Mars/mbadpixels/MBadPixelsTreat.cc
r3802 r3829 201 201 // Do not use blind neighbors 202 202 // 203 if ((*fBadPixels)[ i].IsBad())203 if ((*fBadPixels)[nidx].IsBad()) 204 204 continue; 205 205 … … 225 225 } 226 226 227 //228 // Now the mean is calculated and the values rescaled back229 // to the pixel area230 //231 nphot[i] /= (num*ratio);232 perr[i] = TMath::Sqrt(perr[i]/(num*ratio));233 234 227 // Check if there are enough neighbors to calculate the mean 235 228 // If not, unmap the pixel. The maximum number of blind neighbors … … 241 234 } 242 235 236 // 237 // Now the mean is calculated and the values rescaled back 238 // to the pixel area 239 // 240 nphot[i] /= (num*ratio); 241 perr[i] = TMath::Sqrt(perr[i]/(num*ratio)); 242 243 243 pix->Set(nphot[i], perr[i]); 244 244 } … … 299 299 // Do not use blind neighbors 300 300 // 301 if ((*fBadPixels)[ i].IsBad())301 if ((*fBadPixels)[nidx].IsBad()) 302 302 continue; 303 303
Note:
See TracChangeset
for help on using the changeset viewer.