Back to DataTakingMainPage

Datataking Limits

This is not fully correct please follow the instruction on the DataTakingMainPage (Section DataTaking third point)

• when you reach the ​ Datataking Limits stop datataking!
• switch off voltage
  • BIAS_CONTROL/SET_ZERO_VOLTAGE
• wait a few minutes, so that the camera can cool down
• track another region and try again datataking (you can first test which currents you will get, by following steps):
  • FEEDBACK/START_CURRENT_CONTROL 0.0
  • BIAS_CONTROL/SET_GLOBAL_DAC 1
  • this will ramp up the voltage, so that you can check the currents

• if it is raining
  • switch off voltage
  • close lid
  • park telescope