Changes between Version 3 and Version 4 of Maintenance


Ignore:
Timestamp:
01/11/17 15:29:52 (8 years ago)
Author:
dneise
Comment:

--

Legend:

Unmodified
Added
Removed
Modified
  • Maintenance

    v3 v4  
    1 == Maintenance ==
     1== Maintenance tasks for early 2017 ==
     2
     3If you go to the FACT site for maintenance, be sure to note down everything in the logbook, so it can be found later.
     4Use a searchable thread name such as
    25
    36=== Checking Coolant ===
     
    1215This chain grease has a low viscosity immediately after it comes out of the can, so it can really go into the hinge, then it thickens...
    1316If the can is empty, please buy a new one in the hardware store of the San-Martin supermarket in Brenja-Baja.
     17
     18=== Check cable ties ===
     19
     20The cable ties of all cables from the camera to the container age with time. They should be replaced every now and then.
     21If the old ties look (and feel) still okay, just put new ties next to the old ones. No need to spend time on removing the old ones.
     22
     23Take a picture of the cable tie stock in the container and put it in the logbook.
     24So the next maintenance crew knows if it is necessary to bring new ties.
     25
     26
     27=== Take high resolution pictures of each an everything  ===
     28
     29On your last day please take the time and take many many pictures of everything you see.
     30Often people wonder what is where. How much we still have of what.
     31Your pictures might solve a lot of problems.
     32
     33Please upload all your pictures to the manual upload section and link it
     34to your maintenance logbook entry.
     35
     36
     37=== Drive Oil Check ===
     38
     39If you know how to do it: Check the oil of the drive.
     40
     41
     42=== DAQ Raid ===
     43
     44Check the disks in the raid of DAQ (10.0.100.7)
     45At the moment disk #7 makes problems.
     46
     47
     48=== Replace the Lid Arduino ===
     49
     50Take an Arduino Ethernet (https://www.arduino.cc/en/Main/ArduinoBoardEthernet)
     51and replace the lid arduino with it.
     52Then tell Dominik to flash the firmware onto it and make sure it works.
     53
     54=== Mount the new Lid Motors ===
     55
     56We have new spare Motors for the Lid from LINAK.
     57These should be mounted.
     58
     59=== Light Pulser (?) ===
     60
     61Should we dismount and trash the light pulser?
     62
     63
     64=== Sim card for power switch ===
     65
     66This power switch (http://10.0.100.234) has a sim card, and as usual with prepaid cards
     67... they have to be used every now and then and recharged every now and then.
     68Otherwise they are switched off.
     69
     70We didn't use it for ages, so we have to buy a new one.
     71
     72
     73=== MAGIC Lidar (?) ===
     74
     75We possibly need new hardware for our Lidar Veto.
     76You should bring it with you and deploy it.
     77